Permits are valid for 3 days.

Continuous travel is allowed for loads not exceeding 10′ wide, 14’6″ high, or 110′ in length, including weekends, holidays and red route highways. Travel during daylight hours (½ hour before sunrise to ½ hour after sunset), including Saturdays and Sundays, is allowed for loads not exceeding 18′ wide, 18′ high, or 120′ in length except on Red Route highways. DW21 and 5 MPH conditions on 2-lane highways only allow daytime travel.

Travel is not allowed on major holidays, holiday weekends or on Red Route Highways after 3:00 P.M. Fridays until Sunrise on Saturday, and from 12:00 Noon Sunday to sunrise on Monday if dimensions exceed 10′ wide, 15’6″ high or 110′ in length; and no travel is allowed on major holidays, holiday weekends or after 3:00 P.M. Friday until Monday morning if dimensions exceed 18′ wide, 17′ high, or 120′ in length.

Width: 8’6”
Height: 14′
Length: 53′ semi-trailer, 75′ maximum length if trailer exceeds 53′ or if there is any rear overhang
Overhang: Overall length including overhang up to and including 75′ is legal. Over 75′ needs permit.
Weight: 80,000 Gross Single – 20,000 Tandem – 34,000 Tridem – 42,000
Divisible Loads Exceeding 80,000: You can exceed 80,000 gross without a permit as long as you are legal on all axle/group weights and you are licensed for at least the amount of your gross weight.

Width: 18′
Height: 17′
Length: 150′
Weight: Single – 24,000; Tandem – 48,000*; Tridem – 62,700*; 5 axles, 6 axles or 7 axles depends on spacing
Note: Variable, dependent on axle spacing;

On Interstate Highways:
Width: Over 16’6″ – 1 escort
Height: Not usually required, but over 17′ may depend on route, and over 16′ may have 2 lane detours
Length: Over 120′ – 1 escort
On 2-Lane Highways:
Width: Over 12’6″ – 1 escort, over 14′ – 2 escorts
Height: Over 17′ – 1 escort with high pole
Length: Over 110′ – 1 escort
Weight: Over 54,300 – 55,000 on a Tridem(varies with spacings) – 2 escorts (DW21 Conditions)

Vehicle/load exceeding 10′ in width require “Oversize Load” signs front and rear, and 5″ flashing amber lights, revolving beacon or strobe light(s) are required at each end of the Oversize Load sign on the power unit, or a single beacon light may be used on top of the power unit as long as it is visible from all directions. If the light is blocked by the height/width of the load, the rear of the load should also have a light. “Long Load” sign must be displayed on the rear of combinations exceeding 105′ on non-Interstate routes, and exceeding 120′ on Interstate routes. Over length load does not need signs if less than 110′ total overall length.

Accessibility Tools